Log Bed Kit Assembly Instructions

Step 1Locate All Parts-

2- 47”h Headboard leg posts (2- 59”h for Deluxe)

2- 35”h foot-board leg posts

4- Cross logs (2 for head/ 2 for foot)

Spindles:      Standard & Deluxe beds: Cal King/King(12) Queen(10) Full(8) Twin(6)

                      Small Spindle: Cal King (30) King (30) – Queen (24) – Full (22)

                      Lakeside Edition: Cal King (16) King (16) – Queen (12) – Full (10)

4- Bolts & Washers

2- Wood plugs to conceal bolt holes in Foot-board

**3 Center support slats  –(If you ordered them)

1- Bent log/cross log (for deluxe beds only)

 

Step 2 - Lay out cross logs and spindles – put into place to make sure they all fit BEFORE gluing.

 

For spindle selection (spindles may or may not vary much in size) put bigger spindles towards the middle and smaller spindles towards the outside.

 

If the cross logs are slightly different in size, use the bigger cross logs on the bottom.  As logs are not perfectly straight you may have to use some force to square up the bed so that it does not appear crooked – you may hear some cracking but that is to be expected and does not affect the structure or durability of the bed.

 

***When gluing spindles into cross logs, make sure to put cross logs into legs immediately.  Be sure to glue cross log sections into the legs. Manipulate the logs to become as square as possible before glue sets.

 Step 3 - Side Rails

 Bolts go in the foot-board and headboard through the small holes on each leg.  It does not matter which side the timber side rail is placed on as long as the wide flat side is facing upwards, as your box spring and mattress will be placed on it. 

 Step 4 – If you have not paid for us to finish your bed, it is highly recommended you finish your bed.  Finish bed with a sanding sealer then a clear water based lacquer – we use a semi gloss top coat, sand between coats

PARTS LIST:

2- 47” Headboard Posts OR  2- 59” Posts for Deluxe Headboard

2- 35” Foot-board Posts

4- Bolts & Washers

2- Wood Plugs

3- Center Supports Slats with & 7” Wood Block Footings (If Ordered)

1- Bent Log for Deluxe Headboard (If Ordered)

TWIN  

4- 33" Cross logs

2- 77" Side rails

# OF SPINDLES AS FOLLOWS-

6- Standard or Deluxe

18- Small Spindle

8- Lakeside 

                                                                                                                                FULL

4- 48" Cross logs

2- 77" Side rails

# OF SPINDLES AS FOLLOWS-

8- Standard or Deluxe

22- Small Spindle

10- Lakeside

QUEEN

 4- 54" Cross logs

2- 83" Side rails

# OF SPINDLES AS FOLLOWS-

10- Standard or Deluxe

24- Small Spindle

12- Lakeside

KING

4- 69" Cross logs

2- 83" Side rails

# OF SPINDLES AS FOLLOWS-

12- Standard or Deluxe

30- Small Spindle

16- Lakeside

CAL KING

 4- 65" Cross logs

2- 87" Side rails

Leave a comment

Please note, comments must be approved before they are published